![]() Lid Gasket: turn the lid over and lay a VERY GENEROUS bead of silicon around the lid where it snaps onto the container. Once dry, remove the fan and Saran Wrap leaving a formed gasket on your lid. Press the fan gently into its final mounting position, and let the silicon dry. Then place Saran Wrap over the silicon to prevent the fan from sticking permanently. Fan Gasket: lay a fat bead of silicon on your lid around the hole for your fan. ( Gaskets are Optional) After cutting the holes you can make gaskets for your lid to prevent fog from escaping.Using the screwdriver and deck screws or stainless nut's and bolts, mount your fan in place.To easily add a round duct to your fan, or your output holes, you can purchase our 120mm adapter piece.If you do have backpressure, you can turn down the fan speed. These holes need to be about twice the size (In Total) of the fan hole to prevent any back pressure on the fan. We then cut one or two holes for the output side. The hole for the fan will be marked using the fan opening as a template.If you choose to have one output hole, it needs to be larger than the fan if you want to run the fan at full speed. Two are for output, and one is for your waterproof fan input. Next, we will mark and cut 2 or 3 similar holes in the lid of the water reservoir.Assemble The fogger by plugging the silver transducer into the black transformer and tightening down the locking ring if there is one available.Place the silver transducer into the black float.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |